Multi-Stable Conductance States in Metallic Double-Walled Carbon Nanotubes
© to the authors 2009
Received: 2 December 2008
Accepted: 9 February 2009
Published: 27 February 2009
Skip to main content
© to the authors 2009
Received: 2 December 2008
Accepted: 9 February 2009
Published: 27 February 2009
Electrical transport properties of individual metallic double-walled carbon nanotubes (DWCNTs) were measured down to liquid helium temperature, and multi-stable conductance states were found in DWCNTs. At a certain temperature, DWCNTs can switch continuously between two or more electronic states, but below certain temperature, DWCNTs are stable only at one of them. The temperature for switching is always different from tube to tube, and even different from thermal cycle to cycle for the same tube. In addition to thermal activation, gate voltage scanning can also realize such switching among different electronic states. The multi-stable conductance states in metallic DWCNTs can be attributed to different Fermi level or occasional scattering centers induced by different configurations between their inner and outer tubes.
It is well established that the electrical properties of carbon nanotubes (CNTs) are sensitive to their nanostructures such as diameters, chiralities, defects, etc. [1–5]. In fact, CNTs prefer to be assembled as ropes by close-packing or as multi-walled CNTs (MWCNTs) by arranging them concentrically . In both cases, interactions among nanotubes may significantly modify their electronic structures, and then introduce interesting variations in their electrical properties. For example, in the case of ropes of identical armchair single-walled CNTs (SWCNTs) intertube interactions can break their rotational symmetry, and then the π* and π bands can mix, which will produce a pseudogap about 0.1 eV at the Fermi level [7–9]. As for MWCNTs, the case is a little more complicated because each one of these tubes has different diameters and can have different chiralities.
To explore the effect of the intertube interactions on electrical properties of MWCNTs, double-walled CNTs (DWCNTs) is the best candidate because they are the simplest MWCNTs to be dealt theoretically, which consist of only two tubes having the similar diameters as SWCNTs. In fact, most of the theoretical work on electronic structures of MWCNTs has been done based on DWCNTs [10–17]. Sanvito et al.  found that the interwall interactions may block some quantum conductance channels by investigating the electron transport properties of the commensurate DWCNTs. Roach et al.  inferred that the electronic propagation may follow a non-ballistic law based on the spreading properties of the wave packets in the incommensurate DWCNTs. Kwon and Tománek  found that the weak interwall interactions and changing symmetry can cause four pseudogaps to open and close periodically near the Fermi level during the soft librational motion. Recently, much experimental work has been specifically focused on this issue [17–21]. Kajiura et al.  demonstrated that the electrons pass through DWCNTs quasi-ballistically even at room temperature. Wang et al.  found that free charges in the inner metallic wall may screen the outer semiconducting wall from the gate effect. Moon et al.  determined the current-carrying capacity of each wall of DWCNTs by breaking down their wall sequentially under high bias voltages.
In this paper, we present electrical transport properties of individual metallic DWCNTs with highly transparent contacts. We found that conductance state of DWCNTs is multi-stable at low temperature. At a certain temperature, DWCNTs can switch between two or more electronic states, but below a certain temperature, DWCNTs is stable only at one of them. The temperature for switching is always different from tube to tube, and even different from thermal cycle to cycle for the same tube. In addition to thermal activation, gate voltage scanning can also realize such switching among different electronic states. This electrical behavior of DWCNTs is like the two level fluctuations or random telegraph signals observed in tunnel junctions, metal-oxide-semiconductor field-effect transistors (MOSFETs), and FETs based onp-type semiconducting SWCNTs. It can be attributed to different configurations or small movement between their inner and outer tubes under the equilibrium of the van der Waals interaction between layers with the elastic force of the graphene layers, which can affect the electronic structures of DWCNTs by shifting the Fermi level or inducing occasional electron scattering centers.
DWCNTs used in our measurements were synthesized by pyrolizing C2H2 at a temperature of 900–1100 °C on floating iron catalysts promoted with sulfur. Diameters of outer tubes vary from 1.1 to 2.9 nm, and those of inner tubes from 0.4 to 2.2 nm, which was determined by transmission electron microscopy . DWCNTs were first dispersed in an aqueous surfactant solution (1 wt% lithium dodecyl sulfate) and purified by centrifugation. Thereafter they were deposited on a highly n-doped silicon wafer with 100 nm SiO2 layer by putting one droplet of suspension on the surface. Si wafer has been modified previously by amino-silanization. Electrodes were defined by using an electron beam lithography procedure with standard two-layer resist, and formed by evaporating 15 nm AuPd. Devices containing individual metallic DWCNTs with good source and drain contacts were selected for electrical transport measurements. The DWCNT between two electrodes is 150-nm long. The n-doped Si wafer was used as the back gate. The electrical transport measurements were carried out in a cryostat with a lock-in technique.
Almost all our DWCNT samples exhibit sporadic changes in conductance, but only at a certain temperature, could the continuous switch between two or more levels be observed by careful measurements. After all, this kind of switching is sensitive to temperature, and can disappear even under temperature fluctuations less than 0.05 K. On the other hand, the temperature for conductance switching is different from tube to tube, even different from thermal cycle to cycle on the same tube. We have observed this kind of continuous switching on four different DWCNTs at 2.1, 4.9, 9.9, and even at 49.7 K, respectively.
The evolution of thedI/dV peak around zero bias under small gate voltage (VG) was shown in Fig. 3b, which indicates that this peak shifts and evolves into a dip withVG. This process is completely reversible. In fact, the curve modulated by gate voltage (VG = 0.1 V) is almost the same as the low conductance state curve in the downside of Fig. 3a, which indicates thatVGcan realize switching between these two conductance states and may suggest different Fermi level positions for these two states. From the two-dimensionaldI/dV plots (Fig. 3c,5a) we can make a rough estimate of the capacitance between the DWCNT and the back gate:CG = 4e C/V, wheree is the charge of an electron. The excess chargeQ on the DWCNT induced byVGcan be obtained asQ = CGVG = 4e*0.1 = 0.4e C. Therefore, the different conductance states might be attributed to charges trapping in or escaping from impurities, defects on the DWCNT, or insulating layer adjacent to this tube.
Our individual metallic DWCNT devices have good source and drain contacts. They are much different from the tunnel junctions and MOSFETs that exhibit two level conductance fluctuations [23, 24], and also different from the semiconducting SWCNT-based FETs that exhibit random telegraph noise at high temperature (200 K, for example) and stable electrical hysteresis at low temperature (5 K) [24, 28]. After all the non-localized electrons transport ballistically through the tubes (to be discussed later), the density of impurities or defects in our DWCNTs is very low. Other than charges trapped in impurities or defects, there might be a new mechanism that bring on the multi-stable electronic states, and can be disturbed by the VG and thermal activation.
The electrical transport properties of DWCNTs characterized by multi-stable conductance states might originate from their larruping microstructures: small diameter and two layers. It is said that the weak interwall interactions can activate low-frequency librational motion about and vibration motion normal to the tube axis for the inner tube in DWCNTs . It may be hard to believe that the entire inner tube vibrate or librate; however, it is possible for some small part of the twisted inner tube to vibrate or librate independently under the equilibrium of the van der Waals interaction between layers with the elastic force of the graphene layers. There may be orientational dislocations or twist frozen in DWCNTs during their synthesis. High resolution transmission electron microscopy (HR-TEM) observation revealed that there are smaller (0.39 nm) interlayer spaces with the commensurate lattice and larger (0.54 nm) spaces also in the same DWCNT . Calculations also indicated that the interwall interactions can induce electron transfer from outer tube to interwall region, and then the outer tube can be viewed as being hole doped by the inner tube . When the inner tube (or part of it) changes its configuration about the tube axis sporadically, the amount of charge transfer will change accordingly, and then the Fermi level will shift. We believe that the VG can disturb the charge distribution in the interwall region, and then the configuration of DWCNTs. When the inner tube vibrates normal to the tube axis, the inner tube is close to the outer tube on one side and far away on the other side, which will serve as the new factor for electron scattering .
Therefore, we consider that the multi-stable conductance states in DWCNTs can be attributed to the different configurations of its outer and inner tubes. The continuously switching between two electronic states can be attributed to the locally orientational depinning or melting of a small part of inner tube at certain temperature (TOM, 9.9 K for sample No. 1). When the temperature is lower thanTOM, the two tubes are pinned and the vibration of inner tube is small, and then the DWCNT is electronically stable at different states due to the different configurations. At relatively high temperature (>TOM) one or more parts of inner tube can vibrate freely and independently. All states from different configurations can contribute to the electrical properties at the same time, and then the DWCNT is also stable at a mixed state. When just atTOM, one part of the inner tube can switch continuously and slowly under the equilibrium of the van der Waals interaction between layers with the elastic force of the graphene layers, and so does the conductance. Because the orientational disorder is different from tube to tube, even different from thermal cycle to cycle on the same tube; the temperature for orientational meltingTOMis also different from tube to tube.
We have observed multi-stable conductance states in DWCNTs at liquid helium temperature. At a certain temperature, DWCNTs can switch continuously between two or even more electronic states. Below certain temperature, DWCNTs can be stable at different electronic states due to different Fermi level or occasional scattering centers induced by different configurations between their inner and outer tubes. The temperature for switching is always different from tube to tube, and even different from thermal cycle to cycle for the same tube. This electrical behavior might shed light on the effect of inter-walled interactions on the electrical transport properties of MWCNTs.
This work was supported by the Major Research plan of National Natural Science Foundation of China (Grant No. 90606010), the Program for New Century Excellent Talents in University (Grant No. NCET-07-0278) and the Hunan Provincial Natural Science Fund of China (Grant No. 08JJ1001).